Operation CHARM: Car repair manuals for everyone.

Control Module HVAC: Service and Repair

BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the right side IP insulator Panel.
2. Disconnect the electrical connector from the blower motor control processor.




3. Disconnect the blower motor control processor electrical connector from the blower motor.

IMPORTANT: The opening to the blower motor control processor is slotted. Access to the blower motor control processor opening is limited.




4. Loosen both of the forward bolts.
5. Remove the rearward bolt.

IMPORTANT: Tilt down the rear of the blower motor control processor.

6. Remove the blower control processor.

INSTALLATION PROCEDURE

IMPORTANT: Align the blower motor control processor forward retaining slots onto the screws and seat the blower motor control processor against HVAC module.




1. Install the blower motor control processor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the blower motor control processor rearward screw.

Tighten
Tighten the screw to 1.5 N.m (13 lb in).

3. Tighten the blower motor control processor forward screws.

Tighten
Tighten the screws to 1.5 N.m (13 lb in).




4. Connect the blower motor control processor electrical connector to the blower motor.




5. Connect the electrical connector from the blower motor control processor.
6. Install the right side IP insulator.