Vehicle Speed Sensor (VSS)
Vehicle Speed Sensor (VSS) ReplacementRemoval Procedure
1. Raise and support the vehicle.
2. Remove the right front tire and wheel.
3. Disconnect the vehicle speed sensor (VSS) electrical connector.
4. Remove the VSS bolt (9).
5. Remove the VSS (10) from the extension case.
6. Remove the O-ring (11) from the VSS (10).
Installation Procedure
1. Install the O-ring (11) to the VSS (10).
2. Install the VSS (10).
3. Install the VSS bolt (9).
^ Tighten the bolt (9) to 11 Nm (97 inch lbs.).
4. Connect the VSS electrical connector.
5. Install the right front tire and wheel.
6. Lower the vehicle.