Power Seat Drive Cable: Service and Repair

Drive Cable Replacement - Power Seat

Removal Procedure

Caution: Refer to SIR Handling Caution in Service Precautions.

1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the seat cushion.
3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.




4. Squeeze the collars of the cable in order to release the cable.




5. Pull the cable out of the fittings until the cable ends clear the fittings.
6. Remove the cable or cable/sensor assembly.

Installation Procedure




1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the cable retainers snap into place.
2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
3. Install the seat cushion.
4. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.