Seat Replacement - Front Bucket

Seat Replacement - Front Bucket

Removal Procedure

Caution: Refer to SIR Handling Caution in Service Precautions.

1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Move the seat to the full forward position.




3. Remove the rear seat track fastener trim cover on the inboard seat track.




4. Remove the rear seat track trim cover (1) from the outboard seat track.




5. Remove the seat track fastener trim cover (1) on the outboard track by pushing the cover out from the inside of the seat track with a flat bladed tool.




6. Remove the seat track fasteners.




7. Move the seat to the full rearward position.
8. Remove the front seat track fastener trim covers.
9. Remove the front seat track fasteners.




10. Disconnect the electrical connectors.
11. Remove the seat from the vehicle.

Installation Procedure

1. Install the seat into the vehicle.




2. With seat tilted forward, connect the electrical connectors.






Notice: Refer to Fastener Notice in Service Precautions.

3. Lower the rear of the seat and install the fasteners.

Tighten the seat fasteners to 30 N.m (22 lb ft).




4. Install the seat track fastener trim covers.




5. Install the forward seat track fasteners.

Tighten the seat fasteners to 30 N.m (22 lb ft).

6. Install the front seat track cover.
7. Reposition the seat.
8. Enable the SIR system. Refer to Enabling the SIR System in Seat Belts.