Brake Light Switch: Service and Repair

Stop Lamp Switch Replacement

Removal Procedure
1. Remove the left sound insulator.





2. Rotate the stop lamp/ABS/shift lock switch (2) counterclockwise, then pull to remove the switch.
3. Disconnect the electrical connector from the switch.

Installation Procedure

Important: The stop lamp switch is self adjusting when installed properly in the fully locked position. The twist lock type switch requires no further adjustment.

1. Install the stop lamp switch into the retainer.





2. Press the switch (2) into the retainer until the switch plunger is fully depressed into the switch barrel.
3. Rotate the switch (2) clockwise until travel has stopped and the switch locks fully into position.
4. Connect the stop lamp/ABS/shift lock switch electrical connector to the stop lamp switch (2).
5. Install sound insulator.