Electronic Column Lock Module - Assemble
Electronic Column Lock Module - Assemble - Off VehicleTools Required
^ J41396 Park Lock Cable Pliers
1. Align the electronic lock module assembly (2) with the steering column tilt head assembly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Screw the 3 TORX screws (1) into the electronic lock module assembly (1).
Tighten the 3 TORX screws to 7 Nm (62 inch lbs.).
3. Place steering column lock cylinder set into the OFF position.
4. Place the shift lever clevis into the PARK position.
5. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.
6. Adjust the park lock cable assembly.
6.1. Use the gear shift lever to put the column in the PARK position.
6.2. Put the ignition switch in the OFF-LOCK position. Remove the key.
6.3. Unlock the adjuster ring on the park lock cable assembly with J41396.
6.4. Pull on the cable until the park lock latch contacts the gear shift lever. Release the cable.
6.5. Lock the adjuster ring securely in place on the park lock cable assembly with J41396.
7. Inspect the park lock cable assembly.
7.1. Put the lock cylinder in the OFF-LOCK position. The gear shift lever should not be able to shift out of the PARK position.
7.2. Turn the key to the run position and put the gear shift lever in the NEUTRAL position.
7.3. With the gear shift lever in the NEUTRAL position the lock cylinder should root be able to go into the OFF-LOCK position.
7.4. Put the gear shift lever in the PARK position.
7.5. Put the lock cylinder in the OFF-LOOK position and then remove the key.
7.6. Install the coded key controller and the ignition and key alarm switch assembly only.
7.7. Install the steering column tilt head components.