Ignition & Key Alarm Switch - Assemble

Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the ignition and key alarm switch assembly (2) and secure by using 2 tapping screws (3).
Tighten the screws to 7 Nm (62 inch lbs.).
2. Install the ignition and key alarm connector (1) onto the electronic lock module assembly (4).





3. Connect the coded key controller.
4. Connect the fused jumper assembly connector.





5. Slide the 2 connectors (2) of the Turn signal and multifunction switch assembly onto the bulk head connector (1).





6. Install the coded key controller (2) onto the electronic lock module assembly (1).
7. Install the upper and lower trim covers.