Ignition & Key Alarm Switch - Disassemble

Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle
1. Remove the upper and lower trim covers.





2. Disconnect the coded key controller connector.
3. Disconnect the fused jumper assembly connector.





4. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulk head connector (1).





5. Slide the coded key controller (23 from the electronic lock module assembly (1).





6. Remove the key alarm connector (1} from the electronic lock module assembly (4).
7. Remove the 2 tapping screws (3) from the Ignition and key alarm switch assembly (2).