Ignition Switch
Ignition Switch Replacement - On VehicleRemoval Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the steering column trim covers.
3. Remove the wire harness assembly (4) out of the wire harness strap (5).
4. Remove the wire harness straps (3) from the wire harness assembly.
5. Remove the wire harness strap (2) from the upper tilt head assembly (1).
6. Disconnect the ignition switch electrical connector.
7. Remove the theft deterrent control module (2) from the lock module assembly.
8. Remove the key alarm connector (1) from the lock module assembly (4).
9. Remove the ignition switch retaining screws (3).
10. Remove the ignition switch.
Installation Procedure
1. Install the ignition switch (2) to the steering column.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the ignition switch retaining screws (3).
Tighten the ignition switch retaining screws to 7 Nm (62 inch lbs.).
3. Install the key alarm connector (1) to the lock module assembly (4).
4. Route the electrical harness and connect electrical connections.
5. Install a new wire harness to the upper tilt head assembly (2).
6. Install new wire harness straps to the wire harness assembly (3).
7. Install the wire harness assembly into the wire harness strap (5).
8. Install the steering column trim covers.
9. Enable the SIR system.