SIR Steering Wheel Module Coil - Assemble

Inflatable Restraint Steering Wheel Module Coil - Assemble- Off Vehicle





1. Install the wave washer (1).





2. A new inflatable restraint steering wheel module coil will be precentered. Do not remove the orange tab until installation is complete. Do not depress the tab (1) on the back of the inflatable restraint steering wheel module coil.
3. If reusing the original inflatable restraint steering wheel module coil, it must be centered first.





4. Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the shaft lock shield assembly (1).

Important: The retaining ring (1) must seat securely on the groove of the shaft assembly (2).





5. Install the retaining ring (1).





6. Install the black inflatable restraint steering wheel module coil connector to the fused jumper assembly connector.





7. Install the 4 wire harness straps.
8. Install the wire harness assembly into the wire restraint clip (1).
9. Install the upper and lower trim covers.