Rear Door Window Glass: Service and Repair

Window Replacement - Rear Door

Removal Procedure

Caution: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.

1. Lower the window all the way down.
2. Remove the door trim panel.
3. Remove the window inner belt sealing strip.
4. Remove the window outer belt sealing strip.
5. Raise the window to the full closed position.
6. Tape the window in the closed position.
7. Remove the water deflector to gain access to the window clamp fasteners.




8. Loosen the window regulator to window clamp fasteners 4 revolutions.
9. Lower the window regulator to the full open position.
10. Remove the window by lifting up, flexing forward, and then out.

Installation Procedure




1. Install the window down into the door assembly ensuring that the front of the window is in the front run channel and the rear is outboard of the division post.
2. Grasp the window at the top.
3. Shift the window forward in order to snap the rear of the window into the division post.
4. Locate the window into the 2 window regulator to window clamps.
5. Install the window outer belt sealing strip.
6. Install the window inner belt sealing strip.

Notice: Refer to Fastener Notice in Service Precautions.

Important: Start the vehicle in order to ensure maximum power to the window motor. This is required to fully seat the window for adjustment.

7. Raise the window to the fully closed position.

Tighten the window clamp fasteners to 11 N.m (98 lb in).

8. Install water deflector.
9. Install the door trim panel.