Closing Sunroof From the Open Position

Closing the sunroof from the open position, the sunroof switch must be pressed and held forward until closed. As the close mode is initiated, the sunroof switch low reference circuit is applied to both the sunroof switch open vent signal circuit 12 volt reference and sunroof switch vent signal circuit 12 volt reference inputs, pulling them to 0 volts. As long as the sunroof switch is held to the close position the sunroof module will control voltage to the motor outputs to slide the glass to the closed position. The motor will run until the sunroof limit switch closes, applying the sunroof limit switch low reference circuit to the sunroof limit switch soft stop signal circuit 12 volt reference input, pulling the reference voltage to 0 volts, indicating the closed position has been reached. The wind deflector will retract prior to the sunroof glass reaching the fully closed position. To close the sunshade, this will have to be manually slid forward.