Closing Sunroof From the Vent Position

Closing the sunroof from the vent position, the sunroof switch must be pulled downward once. This will initiate an express close operation. As the close mode is initiated, the sunroof switch low reference circuit is applied to both the sunroof switch open vent signal circuit 12 volt reference and sunroof switch vent signal circuit 12 volt reference inputs, pulling them to 0 volts. The sunroof module will control voltage to the motor outputs to lower the glass to the closed position, same direction as express opening. The motor will run until the sunroof limit switch closes, applying the sunroof limit switch low reference circuit to the sunroof limit switch soft stop signal circuit 12 volt reference input, pulling the reference voltage to 0 volts, indicating the closed position has been reached. To close the sunshade, this will have to be manually slid closed.