Body Control Module Replacement

REMOVAL PROCEDURE




1. Remove the right closeout/insulator panel.
2. Remove the body control module (2). Spread the latch tabs on the sides of the bracket (1) while pulling downward, remove from mounting bracket.
3. Disconnect the electrical connector.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the body control module (2).
2. Install the module to the mounting bracket (1). Slide the module upward and slightly rearward until locking tabs engage.
3. Install the right closeout/insulator panel.
4. Reprogram the body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration. Programming and Relearning