Linear Shift
Linear Shift Assembly Replacement - On VehicleRemoval Procedure
Caution: Refer to SIR Caution in Service Precautions.
1. Disable the SIR system.
2. Remove the shift lever from the linear shift assembly.
3. Remove the steering column trim covers.
4. Disconnect the automatic transmission shift lock actuator from the linear shift assembly.
5. Disconnect the transmission shift cable from the linear shift assembly.
6. Disconnect the park lock cable assembly (1).
7. Insert a small screwdriver into the slot on the lock module assembly and push against the park lock cable locking tab to remove the park lock
8. Remove the linear shift assembly retaining screws.
9. Remove the linear shift assembly.
Installation Procedure
1. Install the linear shift assembly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the linear shift assembly retaining screws.
Tighten the linear shift assembly retaining screws to 62 Nm (46 ft. lbs.).
3. Connect the park lock cable assembly (1) to the lock module assembly.
4. Install the automatic transmission shift lock actuator to the linear shift assembly.
5. Install the transmission shift cable to the linear shift assembly.
6. Adjust the automatic transmission shift lock.
7. Install the steering column trim covers.
8. Install the shift lever.
9. Enable the SIR system.