SIR Steering Wheel Module Coil - Assemble

Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle





1. Install the wave washer (1).





2. Align the block tooth on the race and upper shaft assembly (1) to the 12 o'clock position.

Important: If installing the original inflatable restraint steering wheel module coil, it must be centered first.

3. A new inflatable restraint steering wheel module coil will be pre-centered. Do not pull off the orange tab in the front of the inflatable restraint steering wheel module coil until installation is complete. Do not depress the service lock tab on the back of the inflatable restraint steering wheel module coil.





4. Align the inflatable restraint steering wheel module coil (2) with the horn tower sticking through the shaft lock shield assembly (1).
5. Install the inflatable restraint steering wheel module coil onto the upper shaft assembly.
If a new inflatable restraint steering wheel module coil was installed, remove and dispose of the orange tab.

Important: The retaining ring (1) must seat securely on the groove of the race and upper shaft assembly (2).





6. Install the retaining ring (1).





7. Install the black inflatable restraint steering wheel module coil connector (2) to the fused jumper assembly connector (1).

Notice: Refer to Improper Routing of the Wire Harness Notice in Service Precautions.





8. Install the wire harness assembly (4) into the wire harness strap (5).
Install the wire harness strap (2) into the steering column tilt head assembly (1).
Install the 3 wire harness straps (3) onto the wire harness assembly (4).
9. Install the upper and lower trim covers.
10. Enable the inflatable restraint steering wheel module.