Programming Features - Without Driver Information Center (DIC)

IMPORTANT: Transmitter 1 and transmitter 2 may be programmed separately for 2 different drivers. When programming the personalization features using the keyless entry transmitters, be sure to use the correct transmitter for the driver whose features are currently being programmed.

Enter Programming
To enter the programming mode, perform the following actions:
1. Turn the ignition to RUN.
2. Place the vehicle in PARK.
3. Close all of the doors.
4. Depress and hold the driver side power door lock switch during the entire personalization programming session. The doors will lock to confirm program mode.

Automatic Door Locks
Continue with the following steps in order to personalize the automatic door locks:
1. Press the LOCK button on the correct keyless entry transmitter.
The vehicle will remain in the current mode and react according to the current mode settings (see Automatic Door Lock modes above).
2. Press the LOCK button on the keyless entry transmitter again in order to advance to the next mode. Again the vehicle will react according to the mode settings.
3. Continue to press the LOCK button on the keyless entry transmitter until the desired mode is reached.

Delayed Locking
Continue with the following steps in order to personalize the delayed locking feature:
1. Press the UNLOCK button on the correct keyless entry transmitter.
2. The door locks signal the current mode. If the delayed locking feature is ON, the doors lock. If the delayed locking feature is OFF, the doors unlock.
3. Press the UNLOCK button on the keyless entry transmitter again in order to advance to the next mode.
The door locks lock or unlock to signal the mode change.

Remote Activation Verification
Continue with the following steps in order to personalize the remote activation verification feature:
1. Press the rear compartment release button on the correct keyless entry transmitter. The vehicle will remain in the current mode, and the horn will chirp once.
2. Press the rear compartment release button on the keyless entry transmitter again to move to the next mode. The horn will chirp once.
3. Continue to press the rear compartment release button until the desired mode is reached.

Perimeter Lighting
Continue with the following steps in order to personalize the perimeter lighting:
1. Press the panic button on the correct keyless entry transmitter.
2. The horn signals the current mode. If the perimeter lighting feature is ON, the horn will chirp twice. If the perimeter lighting feature is OFF, the horn will chirp once.
3. Press the panic button on the keyless entry transmitter again in order to advance to the next mode.
The horn will chirp to signal the mode change.

Exit Programming
The following list of events will cause the programming sequence to be terminated:
^ The ignition is moved from the RUN position.
^ The key is used to manually unlock the door, and the door is opened.
^ The driver side power door lock switch is released.
^ The programming time of 2 minutes expires.