Antenna Control Module: Service and Repair

RADIO ANTENNA MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the headliner.
2. Remove the rear shelf trim.
3. Disconnect the antenna module lead from the rear window antenna.




4. Disconnect the antenna module cable from the body harness antenna extension cable.
5. Remove the tape from the antenna module leads.




6. Remove the antenna module bolt.
7. Remove the antenna module from the rear roof header.




8. Disconnect the antenna module cable connector from the windshield antenna.




9. Remove the antenna module cable retainers from the roof inner side rail.




10. Remove the antenna module ground lead bolt.
11. Remove the antenna module ground lead from the front roof header.
12. Gently pull the cable from behind the sunroof drain hoses along the roof inner side rail. Remove the radio antenna module.

INSTALLATION PROCEDURE




1. Position the radio antenna module to the vehicle. Route the cable behind the sunroof drain hoses along the roof inner side rail.
2. Install the antenna module cable retainers to the roof inner side rail.




3. Connect the antenna module cable connector to the windshield antenna.




4. Install the antenna module ground lead to the front roof header.

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the antenna module ground lead bolt.

Tighten
Tighten the antenna module ground lead bolt to 2 N.m (18 lb in).




6. Install the antenna module to the rear roof header.
7. Install the antenna module bolt.

Tighten
Tighten the antenna module bolt to 2 N.m (18 lb in).




8. Connect the radio antenna module cable to the body harness antenna extension cable.




9. Connect the antenna module lead to the rear window antenna.




10. Apply new tape to the radio antenna module leads.
11. Install the rear shelf trim.
12. Install the headliner.