Console Replacement - Front Floor (D55)

Console Replacement - Front Floor (D55)

Removal Procedure





1. Remove the floor console trim plate.
2. Remove the floor console rear compartment mat.
3. Remove the floor console rear compartment bolts.
4. Remove the floor console nuts.
5. Remove the horizontal bolts near the Instrument Panel (IP).
6. Remove the floor console power accessory port. Refer to Power Accessory Port Replace - Front Floor Console (D55) Power Accessory Port Replace - Front Floor Console (D06).
7. Disconnect the wiring harness from the floor console.
8. Pull the floor console rearward in order to release the retainers from the IP.
9. Remove the floor console.



Installation Procedure





1. Position the floor console to the vehicle.
2. Connect the electrical connectors to the floor console.
3. Align the floor console to the retainers at the IP.
4. Push the floor console forward into the retainers in the IP until fully seated. Position the rear of the floor console to the floor panel studs and the console bracket.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Install the floor console horizontal bolts near the IP.

Tighten the floor console horizontal bolts to 5 N.m (44 lb in).
Install the floor console power accessory port.
6. Install the floor console nuts.

Tighten the floor console nuts to 5 N.m (44 lb in).

7. Install the floor console rear compartment bolts.

Tighten the floor console rear compartment bolts to 5 N.m (44 lb in).

8. Install the floor console rear compartment mat.
9. Install the floor console trim plate. Refer to Trim Plate Replacement - Console Front (Trim Plate Replacement - Console Front) .