Rear

DISC BRAKE HARDWARE REPLACEMENT - REAR

Removal Procedure





1. Remove the brake caliper from the mounting bracket and support the brake caliper (2) with heavy mechanic's wire (1), or equivalent. It is not necessary to disconnect the hydraulic brake flexible hose from the caliper.





2. Remove the brake pads (2) from the brake caliper bracket (1).
3. Remove the brake pad retainers (1) from the brake caliper bracket (3).
4. Remove the brake caliper bracket (3).
5. Mount the brake caliper bracket (3) in a vise.

Installation Procedure





1. Clean all parts in clean, denatured alcohol.
2. Dry with low pressure, non-lubricated, filtered air.
3. Inspect the brake caliper bracket for cracks. If cracked, replace bracket.
4. Lubricate the brake caliper pin bolt sleeves with high temperature silicone lubricant.
5. Install the brake caliper bracket.
6. Install the brake pad retainers (1) to the bracket caliper bracket (3).
7. Install the brake pads (2) to the bracket caliper bracket (3).
8. Install the brake caliper to the brake caliper bracket.