Bulb

REMOVAL PROCEDURE




1. Remove the front console and reposition the console slightly rearward.
2. Disconnect the electrical connector (2) from the console compartment lamp switch.
3. Open the console compartment door.
4. Release the retaining tab on the underside of the switch, while sliding the switch rearward.
5. Lift to remove the switch from the top of the console compartment.
6. Remove the console compartment lamp housing on top of the console compartment by pressing the housing towards one side and lifting to release.
7. Slide the lamp housing toward the opposite side to release the remaining tab and lift the housing away from the console compartment.
8. Rotate the lamp socket counterclockwise to release from the housing.
9. Remove the bulb (3) from the socket.

INSTALLATION PROCEDURE




1. Install the bulb (3) to the socket.
2. Install the lamp socket to the lamp housing, then rotate clockwise to secure.
3. Insert one side tab of the lamp housing into position on the top of the console compartment.
4. Press the lamp housing toward the installed side and lower the opposite side into position, the release. Check to be sure that the lamp is secure.
5. Align the console compartment lamp switch to the top of the console compartment.
6. Install the switch into place to secure.
7. Connect the electrical connector (2) to the console compartment lamp switch.
8. Position and install the front floor console. Refer to Console Replacement - Front Floor (D06) or Console Replacement - Front Floor (D55) in Instrument Panel, Gages and Console.

"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes