Fuel Pump Pickup Filter: Service and Repair

FUEL STRAINER REPLACEMENT

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

IMPORTANT: Always maintain cleanliness when servicing fuel system components.




1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
2. Remove the fuel sender assembly.
3. Note the strainer (3) position for future reference.




4. Support the reservoir with one hand. Grasp the strainer with the other hand.
5. Use a screwdriver to pry the strainer ferrule off the reservoir.
6. Discard the strainer.

INSTALLATION PROCEDURE




1. Install the new strainer (4) to the reservoir.
2. Support the reservoir with one hand. Grasp the strainer with the other hand. Twist the strainer into position.
3. Install the fuel sender assembly.
4. Connect the negative battery cable.
5. Inspect for fuel leaks.
5.1. Turn ON the ignition for 2 seconds.
5.2. Turn OFF the ignition for 10 seconds.
5.3. Turn ON the ignition.
5.4. Inspect for fuel leaks.