Body Control Module: Service and Repair

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Remove the left instrument panel insulator.
4. Push the BCM up and move the bottom of the BCM away from and out of the mounting bracket slot in order to remove the BCM.

INSTALLATION PROCEDURE




1. Push the top of the BCM up into the mounting bracket in order to install the BCM. Then, while holding the BCM up, engage the bottom of the BCM into the mounting bracket slot.
2. Connect the BCM electrical connectors.
3. Install the left instrument panel insulator.
5. Set up the new BCM. Refer to Body Control Module (BCM) Programming/RPO Configuration. Programming and Relearning