Ignition Control Module: Service and Repair

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Remove the 14-way electrical connector from the ignition control module (ICM).
3. Disconnect the spark plug wires from the coil assemblies. Before removing the wires, note the position of the wires.
4. Remove the ICM nuts.
5. Remove the ICM from the bracket.




6. Remove the ignition coil screws.
7. Remove the coils (2) from the ICM.

INSTALLATION PROCEDURE




1. Install the coils to the ICM.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the ignition coil screws.

Tighten
Tighten the screws to 4.5 N.m (40 lb in).

3. Install the ICM to the bracket.
4. Install the ICM nuts.

Tighten
Tighten the nuts to 10 N.m (89 lb in).

5. Connect the spark plug wires to the ignition coils.
6. Install the 14-way electrical connector to the ICM.

Tighten
Tighten the screw to 2.1 N.m (19 lb in).