Crankshaft Main Bearing

Crankshaft Main Bearing Cap Bolt/Stud
First Pass 50 Nm 37 ft. lbs.
Final Pass 77 degrees
Crankshaft Main Bearing Bore Diameter 72.1535 - 72.1695 mm (2.8407 - 2.8413 inch)
Crankshaft Main Bearing Bore Out-of-Round 0.008 mm (0.0003 inch)
Crankshaft Main Bearing Journal Width - #1 29.5 mm (1.161 inch)
Crankshaft Main Bearing Journal Width - #2 24.0 mm (0.945 inch)
Crankshaft Main Bearing Journal Width - #3 24.04 mm (0.946 inch)
Crankshaft Main Bearing Journal Width - #4 35.8 mm (1.409 inch)
Crankshaft Main Bearing Clearance - Except #3 0.019 - 0.064 mm (0.0008 - 0.0025 inch)
Crankshaft Main Bearing Clearance - #3 Thrust Bearing 0.032 - 0.077 mm (0.0012 - 0.0030 inch)

Install the crankshaft main bearing cap bolts.
Use the J 36660-A in order to tighten the crankshaft main bearing cap-bolts to 50 Nm (37 ft. lbs.) plus 77°