Trunk / Liftgate: Adjustments

Compartment Lid Adjustment - Rear





1. Perform the front-to-rear and up/down lid adjustment at the lid to hinge bolts. Refer to Hinge Replacement - Rear Compartment Lid (Service and Repair) .
2. Loosen the bolts.
3. Align the lid as necessary.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Tighten the bolts.

Tighten the bolts to 24 N.m (18 lb ft).




Torque Rod Adjustment

Tools Required

J 43300 Torque Rod Adjustment Tool

1. Support the rear compartment lid.
2. Remove the rear compartment trim, as necessary.
3. Install the J 43300 to the torque rod.
4. Adjust the torque rods to one of three positions for the desired tension.
Use a ratchet wrench and a ratchet wrench extension for leverage.
5. Reposition the end of the torque rod in a notch closer to the rear of the vehicle, in order to decrease the amount of effort needed to raise the lid.