Knock Sensor (KS) 2 Replacement
KNOCK SENSOR (KS) 2 REPLACEMENTREMOVAL PROCEDURE
CAUTION: Hot engine coolant may cause severe burns. Although the cooling system has been drained, coolant still remains in the engine water jacket. This coolant will drain with the removal of the knock sensor.
1. Turn OFF the ignition switch.
2. Raise the vehicle. Refer to Vehicle Lifting.
3. Remove the bolts from the splash shield.
4. Drain the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
5. Remove the bolts (2) from the knock sensor heat shield (1) located under the freeze plug (or block heater if equipped).
6. Disconnect the knock sensor wiring harness connector (3) from the knock sensor (4).
7. Remove the knock sensor (2) from the engine block (1).
INSTALLATION PROCEDURE
IMPORTANT: DO NOT apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the sensor's ability to detect detonation.
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the knock sensor (2) into the engine block (1).
Tighten
Tighten the knock sensor to 19 N.m (14 lb ft).
2. Install the knock sensor heat shield.
Tighten
Tighten the bolts to 60 N.m (44 lb ft).
3. Connect the knock sensor electrical connector to the knock sensor.
4. Install the splash shield.
5. Lower the vehicle.
6. Fill the cooling system. Refer to Draining and Filling Cooling System in Cooling System.