Control Module HVAC: Service and Repair

BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the right sound insulator.
2. Remove the IP storage compartment.
3. Remove the IP fuse/relay center.
4. Disconnect the blower motor control processor electrical connector.
5. Remove the blower control processor retaining screws.
6. Remove the blower control processor (1).

INSTALLATION PROCEDURE




1. Install the blower motor control processor (1).
2. Install the screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2 N.m (23 lb in).

3. Connect the blower motor control processor electrical connector.
4. Install the IP fuse/relay center.
5. Install the IP storage compartment.
6. Install the right sound insulator.