Wheel Speed Sensor Jumper Harness Replacement - Front (Right )

Wheel Speed Sensor Jumper Harness Replacement - Front (Right )

Removal Procedure

Important: The wheel speed sensor wiring is included in the engine harness. The wiring between the wheel speed sensor and the heat shrink sealed splices is high-flex cable and must not be repaired or spliced. This procedure replaces the high-flex cable with a jumper harness from a supplied repair kit.

1. Turn OFF the ignition.
2. Raise and support the vehicle. Refer to Vehicle Lifting.





3. Remove the wheel speed sensor connector (7) from the wheel speed sensor (6).
4. Remove the harness grommet (3) from the strut bracket (5).
5. Remove the harness grommet (1) from the rail bracket (2).
6. Remove the harness clip (4) from the rail bracket (2).





7. Cut the engine harness conduit (1) at the indicated location.

Installation Procedure
1. Replace the wheel sped sensor jumper harness.
2. Route the wheel speed sensor jumper through the engine compartment to the wheel well.





3. Install the wheel speed sensor connector (7) to the wheel speed sensor (6).
4. Install the harness grommet (3) to the strut bracket (5).
5. Install the harness grommet (1) to the rail bracket (2).
6. Install the harness clip (4) to the rail bracket (2).
7. Lower the vehicle. Refer to Vehicle Lifting.
8. Perform the ABS Diagnostic System Check.