Ignition Switch

Ignition Switch Replacement

Removal Procedure

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

^ Air bag deployment
^ Personal Injury
^ Unnecessary SIR system repairs
^ In order to avoid the above conditions, observe the following guidelines:
^ Refer to SIR Component Views in order to determine If you are performing service on or near the SIR components or the SIR wiring.
^ If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system.

1. Disable the SIR system.
2. Remove the upper and lower trim covers.





3. Disconnect the theft deterrent control module connector.
4. Disconnect the fused jumper assembly connector.





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulk head connector (1).





6. Slide the theft deterrent control module (2) from the ignition lock cylinder case (1).





7. Remove the key alarm connector (1) from the ignition lock cylinder case (4).
8. Remove the 2 tapping screws (3) from the ignition switch assembly (2).

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the ignition switch assembly (2) and secure by using 2 tapping screws (3).
Tighten the screws to 7 Nm (62 inch lbs.).
2. Install the ignition switch assembly connector (1) onto the ignition lock cylinder case (4).





3. Connect the theft deterrent control module connector.
4. Connect the fused jumper assembly connector.





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly onto the bulk head connector (1).





6. Install the theft deterrent control module (2) onto the ignition lock cylinder case (1)
7. Install the upper and lower trim covers.
8. Enable the SIR system.