Radio/Stereo: Service and Repair
RADIO REPLACEMENTREMOVAL PROCEDURE
1. Remove the IP cluster trim plate.
2. Remove the fasteners (2) that secure the radio (1).
3. Pull the radio (1) rearward.
4. Disconnect the radio electrical connectors (3).
5. Disconnect the antenna lead (4).
INSTALLATION PROCEDURE
1. Connect the radio electrical connector (3).
2. Connect the antenna lead (4).
3. Install the radio (1).
4. Install the radio fasteners (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the fasteners to 1.8 N.m (16 lb in).
5. Install the IP cluster trim plate.