95. Crankshaft Balancer Installation

Crankshaft Balancer Installation

^ Tools Required
- J 37096 Flywheel Holder
- J 45059 Torque Angle Meter

1. Lubricate the seal surface of the crankshaft balancer with engine oil.

Important: The crankshaft position sensor system variation learn procedure must be completed whenever the crankshaft is replaced.





2. Install the crankshaft balancer.
3. Use J 37096 to hold the flywheel.

Notice: Refer to Special Fastener Notice in Service Precautions.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the crankshaft balancer bolt.
^ Tighten the crankshaft balancer bolt to 150 Nm (111 ft. lbs.). Use J 45059 to tighten the crankshaft balancer bolt an additional 76 degrees