Air Temperature Door Replacement - Right
AIR TEMPERATURE DOOR REPLACEMENT - LEFTREMOVAL PROCEDURE
1. Remove the HVAC module assembly.
2. Remove the mode actuator.
3. Remove the recirculation actuator.
4. Remove the right temperature actuator.
5. Remove the left temperature actuator.
6. Remove the fasteners that retain the mode actuator bracket.
7. Remove the mode actuator bracket.
8. Remove the upper HVAC module case screws.
9. Peel back the foam seal at the heater inlet.
10. Remove the upper HVAC module case half.
11. Remove the right temperature door.
INSTALLATION PROCEDURE
1. Install the right temperature door.
2. Install the upper module case.
3. Install the module case screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
4. Reapply the foam seal at the heater inlet.
5. Install the mode actuator and bracket.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
6. Install the left temperature actuator.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
7. Install the right temperature actuator.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
8. Install the recirculation actuator.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
9. Install the HVAC module assembly.