Instrument Panel (IP) - Trim Panel Replacement - Right

Instrument Panel (I/P) Trim Panel Replacement - Right

Removal Procedure





1. Remove the right IP trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement - Right (Instrument Panel (IP) - Outer Trim Cover Replacement - Right) .
2. Remove the right IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory Right (Instrument Panel (IP) - Accessory Trim Plate Replacement - Right Side) .
3. Remove the right IP trim plate fastener (2) from the right IP trim cover area.
4. Gently pry the right IP trim plate (1) rearward in order to disengage the retainers.
The retainers are located on the center most edge of the right trim plate.



Installation Procedure





1. Snap the right IP trim plate (1) into the IP.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the fasteners (2) to the IP.

Tighten the fastener to 2 N.m (18 lb in).

3. Install the right IP accessory trim plate. Refer to Trim Plate Replacement - Instrument Panel (I/P) Accessory Right (Instrument Panel (IP) - Accessory Trim Plate Replacement - Right Side) .
4. Install the right IP trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement - Right (Instrument Panel (IP) - Outer Trim Cover Replacement - Right) .