Tire Monitoring System: Service and Repair

TIRE PRESSURE MONITOR RESET PROCEDURE

IMPORTANT
There are 2 ways to reset the tire pressure monitor (TPM) system. After resetting, the TPM system requires up to 30 minutes of straight line driving in each of the 3 speed ranges to complete the calibration process, for further information, refer to Tire Pressure Monitor Description and Operation.

USING THE DIC
1. Adjust all tire pressures to the recommended kPa/psi. Refer to Tire Placard.
2. Turn "ON" the ignition, with the engine off.
3. Press the "GAGE INFO" button until "TIRE PRESSURE" is displayed.
4. Press and hold the "RESET" button until "TIRE PRESSURE RESET" is displayed.
5. Release the "RESET" button, "TIRE PRESSURE NORMAL" is displayed.
6. Use the scan tool in order to clear the TPM DTC.

USING THE SCAN TOOL
1. Adjust all tire pressures to the recommended kPa/psi. Refer to Tire Placard.
2. Install a scan tool.
3. Turn "ON" the ignition, with the engine off.
4. With the scan tool, select "SPECIAL FUNCTIONS".
5. Select "TIRE PRESSURE RESET".
6. Press the "RESET" soft key and "TIRE PRESSURE NORMAL" is displayed on the DIC.
7. Use the scan tool in order to clear the TPM DTC.