Rear Door Window Glass: Adjustments

Window Adjustment - Rear Door

Removal Procedure





1. Place the door glass in the full-up position.
2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair
3. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
4. Using a marker draw a line on the glass across the header.
5. Connect the power window switch.
6. Lower the window approximately 50 mm (2 in).
7. Disconnect the power window switch.
8. Visually inspect the parallelism of the line to the header.
9. Adjust the inner panel, (if required).
10. Loosen the cam adjusting fastener.
11. Adjust the door window parallel to header.

Notice: Refer to Fastener Notice in Cautions and Notices.

12. Adjust the door window parallel to the header.

Tighten the screw to 9 N.m (80 lb in).




Installation Procedure

1. Install the water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
2. Install the door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair