HVAC System - Automatic

HVAC CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE
1. Remove the front floor console.




2. Remove the HVAC control module mounting screws.




3. Disconnect the electrical connector.
4. Remove the HVAC control module.

INSTALLATION PROCEDURE




1. Connect the electrical connectors.

IMPORTANT: The key should be in the off position when connecting the electrical connectors to ensure proper calibration.




2. Install the HVAC control module.
3. Install the HVAC control module mounting screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2 N.m (18 lb in).

4. Install the front floor console.
5. Start the engine and run for one minute.

IMPORTANT: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.