Procedures

HEATED SEAT CONTROL MODULE REPLACEMENT - FRONT

REMOVAL PROCEDURE




1. Position the seat to the full-up position.
2. Remove the bolts that secure the front seat frame to the floor.
3. Rotate the seat forward to access the heater module.
4. Disconnect the seat electrical harness connector.
5. Pinch the retaining pin (2) together and pull the module (1) out from the seat inboard frame.




6. Disconnect the electrical harness connector (1) from the heater module (2).
7. Remove the heater module from the front seat.

INSTALLATION PROCEDURE




1. Position the heater module to the front seat.
2. Connect the electrical harness connector (1) to the heater module (2).




3. Position the module (1) on the frame and push in to attach the retaining pin (2)
4. Lower the seat.
5. Connect the seat electrical harness connector.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the bolts that secure the front bucket seat adjuster to the floor pan.

Tighten
Tighten the bolts to 42 N.m (31 lb ft).

7. Reposition the front seat to the original position.