Impact Sensor: Service and Repair
INFLATABLE RESTRAINT SIDE IMPACT SENSOR REPLACEMENTREMOVAL PROCEDURE
CAUTION:
- Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the 515 make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
- Refer to SIR Caution in Service Precautions.
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 9.
2. Remove the center pillar lower trim.
3. Loosen the 2 fasteners (2) on the inflatable restraint side impact sensor (1).
4. Remove the inflatable restraint side impact sensor (1) from the center pillar (3).
5. Remove the connector position assurance (CPA) from the side impact sensor connector.
6. Disconnect the side impact sensor connector.
INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.
2. Connect the side impact sensor connector.
3. Install the CPA to the side impact sensor connector.
4. Install the side impact sensor (1) to the center pillar (3).
5. Point the arrow on the sensor toward the front of the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the fasteners (2) to the side impact sensor (1) and tighten using hand pressure.
Tighten
Tighten the fasteners to 10 N.m (89 lb in).
7. Install the center pillar lower trim.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 9.