Ignition Lock Cylinder Case

IGNITION LOCK CYLINDER CASE REPLACEMENT (FLOOR SHIFT)

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the steering wheel from the steering column.
3. Remove the steering column cylinder set from the steering column lock.
4. Remove the turn signal cancel cam.
5. Remove the connector (2) from the steering wheel theft deterrent lock (3).
6. Remove the TORX head screw (1) from the steering wheel theft deterrent lock (3).




7. Remove the steering wheel theft deterrent lock (2) from the ignition lock cylinder case assembly (1).




8. Remove the key alarm connector (1) from the ignition lock cylinder case assembly (2) by doing the following:
8.1. Rotate the key alarm connector (1) 90 degrees.
8.2. Pull the key alarm connector (1) out of the ignition lock cylinder case assembly (2).




9. Remove the 2 tapping screws (2) from the ignition switch (1).Let the switch assembly (1) hang freely.




10. Remove the 3 pan head tapping screws (1) from the ignition lock cylinder case assembly (2).

IMPORTANT: The lock bolt assembly (4) is under slight spring tension from the lock bolt spring (3). Hold the lock bolt (4) in place while removing the ignition lock cylinder case assembly (2).

11. Remove the ignition lock cylinder case assembly (2) from the steering column tilt head assembly (5).
12. Remove the lock bolt assembly (4) from the steering column tilt head assembly (5).
13. Remove the lock bolt spring (3) from the lock bolt assembly (4).

INSTALLATION PROCEDURE




1. Install the lock bolt spring (3) into the steering column tilt head assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column tilt head assembly (5).
4. Push the lock bolt assembly (4) into the steering column tilt head assembly (5) until the lock bolt assembly (4) is flush with the steering column tilt head assembly (5).
5. Align the ignition lock cylinder case assembly (2) with the steering column tilt head assembly (5).
6. Screw the 3 pan head tapping screws (1) into the ignition lock cylinder case assembly (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 7 Nm (62 lb in).




7. Install the ignition switch (1) onto the ignition lock cylinder case assembly.
8. Screw the 2 tapping screws (2) into the ignition switch (1).

Tighten
Tighten the screws to 1.5 Nm (13 lb in).




9. Install the steering wheel theft deterrent lock (2) onto the ignition lock cylinder case assembly (1).




10. Screw the TORX head screw (1) into the steering wheel theft deterrent lock (3).

Tighten
Tighten the screw to 1.5 Nm (13 lb in).

11. Reconnect the connector (2) to the steering wheel theft deterrent lock (3).




12. Install the key alarm connector (1) onto the ignition lock cylinder case assembly (2) by doing the following:
12.1. Push the key alarm connector (1) into the ignition lock cylinder case assembly (2).
12.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector locks into place.
12.3. Install the steering column lock cylinder set only.
12.4. Install the turn signal cancel cam.
12.5. Install the steering wheel from the steering column.
12.6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3.