Ignition Lock Cylinder Case

IGNITION LOCK CYLINDER CASE REPLACEMENT (TILT COLUMN)

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the steering wheel from the steering column.
3. Remove the turn signal cancel cam.
4. Remove the ignition lock cylinder.
5. Remove the ignition switch only.
6. Remove the park lock cable assembly (1) from the ignition lock cylinder case.
6.1. Place the steering column lock cylinder set into the OFF position.
6.2. Place the shift lever clevis into the PARK position.
6.3. Use a small blade to push against the locking tab on the end of the park lock cable assembly (1).
6.4. Disconnect the park lock cable assembly (1) from the ignition lock cylinder case.




7. Remove the 3 pan head tapping screws (1) from the ignition lock cylinder case (2).
Remove the ignition lock cylinder case (2) and the lock bolt assembly (4) from the steering column tilt head assembly (5).

IMPORTANT: The lock bolt assembly (4) is under slight spring tension from the lock bolt spring (3). Hold the lock bolt (4) in place while removing the ignition lock cylinder case (2).

8. Remove the lock bolt spring (3) from the lock bolt assembly (4).

INSTALLATION PROCEDURE




1. Install the lock bolt spring (3) into the steering column tilt head assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column tilt head assembly (5).
4. Push the lock bolt assembly (4) into the steering column tilt head assembly (5) until the lock bolt assembly is flush with the steering column tilt head assembly (5).
5. Align the ignition lock cylinder case (2) with the steering column tilt head assembly (5).
6. Screw the 3 pan head tapping screws (1) into the ignition lock cylinder case (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 7 Nm (62 lb in).




7. Place steering column lock cylinder set into the OFF position.

CAUTION: Refer to SIR Inflator Module Coil Caution in Service Precautions.

8. Place the shift lever clevis into the PARK position.
9. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
10. Install the ignition switch only.
11. Install the ignition lock cylinder.
12. Install the turn signal cancel cam.
13. Install the steering wheel to the steering column.
14. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.