Tilt Head

STEERING COLUMN TILT HEAD HOUSING REPLACEMENT

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the turn signal cancel cam assembly.
3. Remove the turn signal and multifunction switch assembly only.
4. Slide the turn signal switch housing off of the steering column shaft assembly.
5. Remove the tilt head housing and steering shaft as an assembly.
6. Remove the tilt head from the steering shaft.

INSTALLATION PROCEDURE




1. Install the tilt head onto the steering shaft.
2. Install the tilt head housing and steering shaft as an assembly.
3. Slide the turn signal switch housing onto the steering column shaft assembly.

IMPORTANT: The switch mounting bracket must be pressed firmly against the steering column tilt head.

4. Install the turn signal and multifunction switch assembly only.
5. Install the turn signal cancel cam assembly.
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.