Instrument Panel (IP) - Trim Panel Replacement - Left

INSTRUMENT PANEL (I/P) TRIM PANEL REPLACEMENT - LEFT

REMOVAL PROCEDURE
1. Remove the left IP trim cover.
2. Remove the right IP accessory trim plate.
3. Remove the left IP accessory trim plate.
4. Block the wheels.
5. Place the transmission control lever into the FIRST (1) gear position, in order to allow clearance for the IP cluster trim plate removal.




6. Remove the IP cluster trim plate fastener (4) from the left IP trim cover area.
7. Gently pry the IP cluster trim plate (3) rearward in order to disengage the retainers.
8. Disconnect the electrical connectors (1, 2).

INSTALLATION PROCEDURE




1. Connect the electrical connectors (1, 2).
2. Align the IP cluster trim plate (3) to the IP.Push inward to fasten.
3. Install the IP cluster trim plate fastener (4) to the IP.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fastener to 1.9 N.m (17 lb in).

4. Place the transmission control lever into the PARK position.
5. Remove the blocks from the wheels.
6. Install the left IP accessory trim plate.
7. Install the right IP accessory trim plate.
8. Install the left IP trim cover.