Instrument Panel (IP) - End Bracket Replacement - Right

BRACKET REPLACEMENT - INSTRUMENT PANEL (I/P) END RIGHT

REMOVAL PROCEDURE
1. Remove the IP assembly.




2. Remove the fasteners (2) from the right IP end bracket (1) to the A-pillar.
3. Remove the right IP end bracket (1).

INSTALLATION PROCEDURE




1. Install the right IP end bracket (1) to the A-pillar.
2. Install the fasteners (2) to the right IP end bracket (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the fasteners to 55 N.m (41 lb ft).

3. Install the IP assembly.