Operation CHARM: Car repair manuals for everyone.

Intake Manifold Replacement - Lower



Intake Manifold Replacement - Lower
Removal Procedure





1. Turn the ignition OFF.
2. Remove the air inlet duct.
3. Remove the fuel pressure and evaporative emission (EVAP) hoses from the engine.
4. Disconnect the BARO sensor electrical connector.
5. Important: Do not disconnect the engine control module (ECM) electrical connectors. Remove the ECM bracket with the ECM and reposition aside.
6. Disconnect the purge solenoid electrical connector.
7. Disconnect the purge solenoid electrical connector.





8. Remove the wiring harness from the right side of the intake manifold.





9. Disconnect the fuel injector electrical connector.





10. Remove the throttle body electrical connector.
11. Remove the brake booster vacuum hose and check valve from the brake booster.





12. Remove the positive crankcase ventilation (PCV) hose from the intake manifold.





13. Remove the intake manifold bolts (1-6).





14. Remove the intake manifold.
15. Disassemble the intake manifold as necessary. Refer to Intake Manifold Disassemble.
16. Clean and inspect the intake manifold and the sealing surfaces. Refer to Intake Manifold Cleaning and Inspection.

Installation Procedure
1. Assemble the intake manifold as necessary. Refer to Intake Manifold Assemble.





2. Install the intake manifold.





3. Install the PCV hose to the intake manifold.
4. Install the brake booster vacuum hose and check valve to the brake booster.





5. Install the throttle body electrical connector.





6. Connect the fuel injector electrical connector.





7. Notice: Refer to Fastener Notice in Service Precautions.

Install the wiring harness to the right side of the intake manifold.
^ Tighten the wiring harness bracket bolts to 10 Nm (89 inch lbs.).





8. Connect the purge solenoid electrical connector.
9. Install the ECM bracket with the ECM.
10. Connect the BARO sensor electrical connector.
11. Install the fuel pressure and EVAP hoses to the engine.
12. Install the air inlet duct.