15. Crankshaft Balancer Removal

Crankshaft Balancer Removal

^ Tools Required
- EN 46106 Flywheel Holding Tool
- J 38416-2 Crankshaft Button
- J 41816 Crankshaft Balancer Remover





1. Install the EN 46106 through the starter mounting hole.





2. Remove the crankshaft balancer bolt.





3. Install the J 38416-2 in the nose of the crankshaft.
4. Install the J 41816 in order to remove the crankshaft balancer.
5. Tighten the center bolt of the J 41816 in order to pull the crankshaft balancer off of the crankshaft.
6. Remove the J 41816 from the crankshaft balancer.