Camshaft Position (CMP) Sensor Replacement - Bank 1 (Right) Intake

CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT - BANK 1 (RIGHT) INTAKE

REMOVAL PROCEDURE
1. Turn the ignition OFF.




2. Remove the camshaft position (CMP) sensor electrical connector.




3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.

INSTALLATION PROCEDURE




1. Install the CMP sensor.
2. Install the CMP sensor bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the CMP sensor bolt to 10 N.m (89 lb in).




3. Install the CMP sensor electrical connector.