87. Intake Manifold Installation - Upper

Intake Manifold Installation - Upper





1. Install the upper intake manifold gasket.
2. Install the upper intake manifold.





3. Install the upper intake manifold bolts and studs.
Tighten the upper intake manifold bolts and studs in sequence to 10 Nm (89 inch lbs.).

Notice: Refer to Fastener Notice in Service Precautions.






4. Install the throttle body gasket.
5. Install the throttle body.
6. Install the throttle body nuts and bolts.
Tighten the throttle body nuts and bolts to 10 Nm (89 inch lbs.).





7. Install the engine wiring harness heat shield.
8. Install the engine wiring harness heat shield bolt and nut.
Tighten the engine wiring harness heat shield bolt and nut to 10 Nm (89 inch lbs.).





9. Install the fuel injector rail.
10. Install the fuel injector rail nuts.
Tighten the fuel injector rail nuts to 10 Nm (89 inch lbs.).





11. Install the ignition control module assembly.
12. Install the ignition control module assembly bracket nuts.
Tighten the ignition control module assembly bracket nuts to 50 Nm (37 ft. lbs.).
13. Connect the ignition control module connector to the ignition control module assembly.
14. Install the wiring harness to the fuel rail.
15. Install the spark plug wires to the retaining clips and spark plugs.