95. Engine Prelubing

Engine Prelubing

Tools Required
^ J45299 Engine Preluber





1. Remove the engine oil filter, fill with clean engine oil.

Important: A constant/continuous flow of clean engine oil is required in order to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.


2. Install the oil filter.
Tighten the oil filter to 30 Nm (22 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

3. Locate the oil pressure sensor on left side of engine and remove.
4. Install the 1/4 inch adapter P/N 509373.





5. Install the flexible hose to the adapter and open the valve.
6. Pump the handle on J45299 to flow a minimum of 1-2 quarts of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
7. Close the valve and remove the flexible hose and adapter from the engine.
8. Install the oil pressure sensor.
Tighten the oil pressure sensor to 16 Nm (12 ft. lbs.).
9. Top off the engine oil to the proper level.