Power Steering Cooler Pipe/Hose

POWER STEERING COOLER PIPE/HOSE REPLACEMENT (L26)

Removal Procedure
1. Remove the drive belt.
2. Place a drain pans under the vehicle as needed.
3. Remove the right front tire and wheel assembly.






4. Remove the power steering cooler hose from the steering gear.






5. Remove the power steering cooler hose from the power steering pump.
6. Unclip the power steering cooler hose from any front frame retainers as needed.
7. Remove the power steering cooler hose from the vehicle.

Installation Procedure
1. Position the power steering cooler hose to the vehicle.
2. Clip the power steering cooler hose to any front frame retainers as needed.






3. Install the power steering cooler hose to the power steering pump.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.






4. Install the power steering cooler hose to the steering gear.

Tighten
Fitting to 27 Nm (20 lb ft).

5. Clean any excess fluid from the vehicle and remove the drain pans.
6. Install the right front tire and wheel assembly.
7. Install the drive belt.
8. Fill and bleed the power steering system. Service and Repair